Installation Sheet

ASSEMBLY INSTRUCTION
®
MODEL #MIT-A8020-AG
30″
16″
7.2″
For Hard-wired
For Plug-in
How to Install
All electrical components must be
installed by a licensed electrician
in accordance with the National
Electric Code and the appropriate
local electrical codes.
You will need 1-Medium
60 watts Max Bulb not included
USE LED BULBS FOR EXTENDED USE
This is a convertible piece. Installation steps for both
Hard-Wire and Plug-In options are below
For Hard-wired installation, please proceed as follows:
1.Remove the plug wires from the fixture wires.
2. Remove the Nut (K) from the bottom of Back Plate (B)
and cover the hole with plug (J).
3.Attach the Shade (G) onto Socket (F) and secure it by
Socket Ring (H).
For Plug-in installation, please proceed as follows:
1.Connect Rod (I) to the bottom of Back Plate (B).
2. Determine the desired location you'd like to put
this fixture on the wall, and mark two points on it with
same distance as between the holes on the Back
Plate (B).
3.Drill the holes at the marked points and insert the
anchors into the holes in the wall, Attach the mounting
plate onto the wall by anchor screws.
4.Attach the Back Plate (B) onto mounting plate.
2.5″
13″
WARNING: This product can expose you to Lead,
which is known to the State of California to cause cancer
and/or birth defects or reproductive harm. For more
information go to www.P65Warnings.ca.gov