Instruction manual

44
www.cs-instruments.com
Description Order no.
Drilling jig incl. drill (Ø 13 mm) 0530 1108
High-pressure protection recommended for installation from 10 to 50 bar 0530 1105
Useful accessories:
Measuring sections
• Drilling under pressure
External thead Pipe (outerø x wall thickness) Total length Order no.
G 1/4” 20.0 x 7.0 mm 180 mm 4000 0006
G 1/2” 21.3 x 2.6 mm 500 mm 4000 0015
G 3/4” 26.9 x 2.6 mm 600 mm 4000 0020
G 1” 33.7 x 3.2 mm 750 mm 4000 0025
G 1 1/4” 42.4 x 3.2 mm 900 mm 4000 0032
G 1 1/2” 48.3 x 3.2 mm 1000 mm 4000 0040
G 2” 60.3 x 3.6 mm 1250 mm 4000 0050
G 2 1/2” 76.1 x 3.6 mm 1500 mm 4000 0065
from DN 80 with flange DIN 2633
DN 80/88.9 88.9 x 2.0 mm 1850 mm 4000 0080
DN 100/114.3 114.3 x 2.0 mm 2104 mm 4000 0100
DN 125/139.7 139.7 x 3.0 mm 2860 mm 4000 0125
DN 150/168,3 168,3 x 3,0 mm 3110 mm 4000 0150
Measuring sections for precise measurements
Meas. section made of stainless steel 1.4301 incl. ball valve, up to DN 65 (G2 1/2”)
with external thread, from DN 80 with weld neck flange according to DIN 2633.
Drilling jig for drilling under pressure
By means of a special drilling device a measuring site with 1/2" ball valve can be
easily set up within a few minutes.
As an alternative to the welding of the 1/2” fitting also a spot drilling collar
(see page 45) can be used.
• Measuring section 1/2”
• Measuring section 1/4”
• Drilling jig • High-pressure
• protection
Consumption