Installation Guide

c
L
20.65
55.3
120
85
17.5
CL200
Installation
Instructions
for Passage or
Privacy Handle
2
PAGE
BEFORE YOU START:
The door must be installed and
adjusted square to the closing
jamb for the handle to close
properly onto the striker.
INSTRUCTIONS
1. Remove handle from packaging
This handle is temporarily screwed to an aluminium
frame using the same screws (6 in total) needed to
install it to your door. As you remove the handle from the
aluminium frame, take note of how it is fitted as you will
be fitting it to your door in the reverse order (diagram a).
2. Cut out door
Mark a horizontal line on the
face of the door where the
centre of the handle is to be
positioned (diagram b).
Align the centre line on the
aluminium frame with the
centre line on the door.
Trace around the inside of the
aluminium frame as shown.
Repeat on the other side of
the door.
Transfer top and bottom lines
across the front edge of the
door.
Cut out the door along the
marked lines.
4. Fit the handle
a) Screw the wedges into the
rebates in the door as shown
(diagram d) using the 4 x flat
head screws which were part
of the packaging.
Aluminium
frame
Transfer
across
front
edge
Mark
inner
edge of
template
Horizontal
line
Ø3mm (1/8”)
holes
35mm (1-3/8“)
deep
Drilling
template
3. Drill fixing holes
Remove the plastic drilling
template from the back of the
aluminium packaging frame.
Place the template into the
rebate with the bosses facing
towards you (diagram c).
Line it up on the centre of the
door thickness.
Using a Ø3mm (1⁄8”) drill,
spot through all six holes.
Remove the template and
drill holes to depth of 35mm
(1-3/8”).
Wedges
Flat head
screws (4)
5mm (1/4”) gap
under head
DO NOT FULLY TIGHTEN THE
SCREWS.
The underside of the
screw heads should stop
approximately 5mm (1/4”)
above the top of the wedges.
This handle IS NOT handed.
Handing is determined at time of
fitting by which way round the side
handles are fitted to the door.
DO NOT throw away the packaging
until the handle is fully fitted.
Go to page 3 (overleaf)
COMPONENTS
(Privacy Handle Shown)
Top plastic cap
Bottom plastic cap
Striker
Striker
screws (2)
Aluminium
frame
(cut out
template)
Drilling
template
Side
handle
Side
handle
Flat head
screws (4)
Face
plate
screws
(2)
Face
plate
Wedges
(2)
Snib button
(may vary)
Snib joining
pin
Alignment
pins (2)
IMPORTANT:
A. The aluminium frame is used as a template to mark out
the door cut out.
B. The rectangular plastic moulding is used as a drilling
template.
C. The bottom packaging cap has the striker fitted to it
(Privacy Handles). The snap out plastic moulding is used
to mark the striker position on the closing jamb and to
test that the lock functions correctly.
Remove the two face plate screws using a 3.5mm (9⁄64”) hex
screwdriver bit (supplied).
Pull the face plate out from between the side handles.
Remove the four remaining screws now visible after removal of
the face plate.
c
a
d
b
Alternate snib
joining pin
Hex screwdriver bit
Striker setting tool