Operating instructions
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly,
a fire or explosion may result causing properly damage,
personal injury or loss of life.
A. This appliance does not have a pilot. It is equipped with an ignition
device wich automatically lights the burner. Do no t
try to light the
burner by hand.
B. BEFORE OP ERATING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your
building.
• Immediately call your gas supplier from a neighbor’s phone.
Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control knob. Never
use tools. If the knob will not push in or turn by hand, don’t try to repair
it: call a qualified service technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified technician to inspect the appliance
and to replace any part of the control system and any gas control
which has been under water.
1 Start up procedures
• Inspect for proper baffling insertion into flue passes. All clean-
out doors properly sealed. Burner door closed and properly
latched.
• Gas and oil systems ready. Proper vent connections. Required
combustion and ventilation air provided.
• Waterside of system properly filled and vented of air.
• Lighting instruction followed.
• To be performed by a licensed tradesperson in accordance with
the guidelines shown in this manual. Follow burner
manufactures instructions.
• Mandatory factory start-up report to be completed and returned
to comply with the warranty process.
• Proper operating instructions of equipment to be related to
operating personnel.
2 Shut-down procedures
• Disengage all electrical power switches to heating system
burners, pumps. Isolate all boiler valves and fuel valves.
• For off-season shutdown, open boiler combustion flue ways and
clean. Ensure venting, chimney, combustion and ventilation air
openings free from blockage. Do not drain waterside of system.
- Shutoff fuel supply lines
17
85534150
11-20-09