User`s guide

192 Guardall Director V4.74 User's Guide 21-0381E v4.7.4
Pick-List (bottom of the
form)
-Panel (optional): If the tree is not set to
show items on a panel-by-panel basis,
you will be able to select a panel here
(for systems that have more than one).
A "Panel Group" reference may also be
shown here, or
you can set the 'tree' to list
configuration topics separately for each
panel. For more information, refer to "Other
Desktop Choices".
 Standard  and 
Alternate 
(for 1
st
& 2
nd
card formats to be used at the
same time)
Two card types can be set up, allowing either
Wiegand / Prox and Magstripe/barcode, or two types of
Wiegand / Prox cards to be used with each specific
panel.
All length values refer to number of characters for
magnetic stripe cards (MS), or number of bits for
Wiegand technology (W).
- Token Format: This allows defining
parameters for the basic card/token types (as
selected for each specific reader).
"Wiegand" pertains to cards/tokens for readers with
Wiegand data-format (Wiegand, Proximity, etc.).
Similarly, "Magstripe" pertains to cards for readers
with magstripe output (magstripe, bar-code, etc.).
-------------------------
- [Wiegand 26]: This automatically sets the card-
format values for the standard 26-bit Type-A
Wiegand format.
- [Wiegand 36]: This automatically sets the card-
format values for the proprietary 36-bit Wiegand
format.
Card Site (Site/System Code)
- Site Required: This enables/disables site code
checking. If selected, cards without one of the
specified site codes will be denied access.
- Site Code 1, 2, 3: If site-code checking is
enabled, only cards encoded with one of these
site codes will be allowed access at this site
(e.g., 0004, 1234, 9999).
- Position: The start position of the site code
(1-40);
- Length: The length of the site code (MS: 1-4;
W: 1-16).
Card Version (Version-Number)
This feature requires  V3.2 panel firmware and  V1.5
door/elevator controller module firmware. For an
additional setting, refer to "AutoUpdate Card Version",
under  Special  (to follow).
- Version Required: This enables/disables
version number checking (allows fixed-ID cards
to be re-issued if lost or stolen).
- Position: The starting position of the version
number (1-40).
- Length: The length of the version number (MS:
1-2; W: 1-8).
Card ID
- Position: The starting position of card ID
number (1-40);
- Length: The length of card ID number (MS: 4-9;
W: 1-32).
32-Bit Cards: Supported with panel firmware  V3.2,
and door/elevator controller module firmware 
V1.5
(prev. 20 bit / 6 digits).
V3.2 panels: MaxID=999999999; V3.31 Panels:
MaxID=4
294 967 295.
- Bits per Card: The length of the card data in
bits (Wiegand), or characters (magnetic stripe).
This can be up to 40.
- Bits per Character
(magstripe only): The number
of bits used to identify each character of data on
a magstripe card (future use; fixed as 4).
Odd Parity
These settings pertain to odd-parity checking, which
helps to identify card 'misreads'.
Configuration System Access
Note: For a system set for intrusion-only (under Account Information),
the "Access" tab will appear as "Token Format".