User`s guide

236 Guardall Director V4.74 User's Guide 21-0381E v4.7.4
Example A: With "(Condition1 AND (Condition2 OR
Condition3))" the output will trigger only if Condition2
or 3 (or both) is in effect at the same time as
Condition1.
Example B: With "((Condition1 OR
Condition2)
AND
(Condition3 OR Condition4))" the output will
trigger if at least one item from each side of the "AND"
is in effect at the same time.
Example C: If you start with example B, right-
click Condition1, select "Insert Operation on
right" , and set it as an AND function, you will
have: "(((Condition1 AND NewCondition) OR
Condition2) AND
(Condition3 OR
Condition4))".
The equation would be evaluated in this order:
1) C1 AND
New; 2) Result1 OR C2; 3) C3 OR
C4; 4) Result2 AND
Result3.
Note: The deepest-nested brackets are analyzed first.
Equations with Cadence (pulsing)
To obtain a pulsing output, System - Cadence
functions must be "ANDed" with the portion of the
equation to which they apply. If all conditions of the
equation are to cause a pulsing output, the cadence
function should be set up first, with everything else
appearing within a pair of brackets on the left or right.
Tip
: "ANDing" different cadence selections (or none)
with the various segments of an otherwise "OR"
equation allows a single output to respond differently
to different types of events.
For one type of cadence for an entire equation
(for example):
 Set up a System - Cadence function first;
Also See: "Cadence (Getting the Output to Pulse On
and Off)", previous/above.
 Right-click within it, and select Add
Operation on right;
 Set up the second operation as desired,
being sure to use an "AND" operator;
 Insert any other operations by right-clicking
on segments to the right of the cadence
function (not within the cadence function
itself).
Programmable Output
Functions
  Failed to Close
: Area schedule expired, & no
one armed the system;  In Window
: Schedule active;
 Out Window
: Schedule expired;  Pseudo: Internally
monitored conditions (Ref: Config. System
Equipment);  Version "E"
: This indicates conditions
pertaining to European monitoring requirements
(requires Director V4.2).
System (events pertaining to the specific
main/system panel)
:
System Tone if Module Fail
Fallback sonalert (at control panel) if Module
Bus fails. Provides 1 sec. output every 8 sec.
And activates if there is no operational
keypad in an area with programmed keypads.
System Ground Start
Ground Start (can only be used on B004 -
main panel output 4)
System Fully On
When system is FULLY ON
System Partially On
When system is PARTIALLY ON (Partially or
Fully On for Europe Version)
System Fully Off
When system is FULLY OFF
System In Alarm
When system is IN ALARM - resets when
point(s) restore (includes pseudos & tampers)
System Siren
Follows ALARM & FIRE siren (steady)
System Siren Fire (1 sec.)
Follows ALARM siren - steady for BURG /
EMERG and provides 1 sec on/off for FIRE
per Keypad Tone. Exception
: If selected for
the siren output (#3 on main panel), this
enables UL fire-cadence: ½ sec on/off three
times, 1sec pause, and repeats.
System Siren Fire (2 sec.)
Follows ALARM siren - steady for BURG /
EMERG and provides 2 sec on/off for FIRE
System Digital Trouble
Phone line trouble (follows report delay or
line failure)