User`s guide

21-0381E v4.7.4
Welcome Report Control Admin
Sys Config Tech-Ref
239
Area Pseudo
When any 'Pseudo' condition is in effect.
Area Walk Test
Area is in ‘Walk’ or ‘Hold-up’ test.
Area Entry / Exit
When area Entry / Exit delay is in progress –
provides a steady output (STAY & ON).
Area Entry
When area Entry delay is in progress -
provides a steady output (STAY & ON).
Area Exit
When area Exit delay is in progress -
provides a steady output (STAY & ON).
Area Ready
When the area is ‘Ready To Arm’ - i.e. all
points are secure.
Area Open Window
When the active/open window of the area's
schedule is in effect.
Area Closing
When the area schedule is expiring in 15
minutes.
Area Door Unlocked
Area Door Locked Out
Area Door Held Open
Area Door Forced
Area Door Tamper
Door Tampers (door contact condition: no
EOL resistor etc.)
Area Door Open
Area Door Secure
Area Door Sensor Trouble
Door Sensor Troubles (magnetic bond sensor
not ok)
Area Panic Token Detected
Area Counter reaches Min
Considered 'empty'; User Count <= Minimum
Area Counter reaches Max
Considered 'full'; User Count >= Maximum
Area No Detected Activity
Area Activity Detected
Area 15 Min before Scheduled Arm to "On"
Area 15 Min before Scheduled Arm to "Stay"
Area 15 Min before Scheduled Disarm Arm to "Off"
Area Schedule in Window
Area Auto-Command Schedule In Window
Area Failed to Close
Area Any point in tamper in area
Area Armed with Bypasses in Effect
Area Force Armed
Armed with some input points 'tripped'.
Area User Lockout in Effect
Re: Bad Card/PIN monitoring.
Area Wandering Patient Detected
Area Version "E" Siren
Area Version "E" Confirmed Alarm Strobe
Area Version "E" Fire
Area Version "E" Personal Attack
Area Version "E" Unconfirmed Alarm
Area Version "E" Set/Unset
Area Version "E" Freezer/Fire Fault
Area Version "E" Bypass in Effect
Area Version "E" Confirmed Alarm
Confirmed alarm – European Version (Active
when more than one detector is activated
during a single armed state).
Version "E"
: Pertains to European monitoring
requirements.
Point (if event occurs at a specific Point):
Point Normal (OK)
Point Open (tripped or tampered--any time)
Point Open (disarmed)
Tripped or tampered when area is Off or
Stay)
Point Open (armed)
Tripped or tampered when area is ON
Point Alarm
Tripped when area is ON
Point Bypassed
Point Preprocess Delay
PreAlarm Warning is in effect.
Point Tamper
Point Point in Delay
Point is in Delay. Follows a Custom Pt Type
that has a time delay.
Point Confirmed point command
Positive Confirmation of Point Command
Activation.