User`s guide

ManualsBrandsCSG Security ManualsComputer equipmentNetVision Plus

21-0381E v4.7.4

Welcome Report

Control Admin Sys Config Tech-Ref

- Momentary Normal Unlock: This unlocks the

door for a duration equal to the standard "unlock

duration". This is the same as someone gaining

entry with an access card or token.

- Momentary Extended Unlock: This unlocks

the door for a duration equal to the "extended

unlock duration". This is the same as a user

who is set for "extended unlock/challenged"

gaining entry with an access card or token.

- Pending Unlock: This is an unlock command

that waits for one person to enter the facility at

the specific door.

- Grant Last User -- Reader 1 (or 2): If the last

user at a reader was denied access, this will

issue a 'Momentary Unlocking', and log that

card/user as being granted entry.

 Cards can be denied due to being expired, locked

out, wrong time, wrong door class, etc. -- as long as

they are defined in the system.

 This feature will be unavailable if someone else is

granted entry, or after 5 minutes from the time the

person was denied access (although they can

simply present their card/token again).

 This may be used in conjunction with an event-

triggered camera-view for the door (so a remote

attendant can see the person).

Related Topics

: Visually Verifying Users (Photo-

Verification)"

 This cannot

be used (or does not apply) with:

- Cards being enrolled or disabled at a reader set to

do this (although it will apply for cards denied due

to wrong area/time, etc.);

- Access being denied due to door interlock

violations or area/disarm authority issues.

___________________________________________

Input-Point Commands

(After right-clicking a Sensor)

Also See: "Common Commands", previous/above.

-------------------------------------------------------------------------

- Bypass / Remove Bypass: "Bypass" allows

arming an area with a tripped or faulty input

point (sensor). "Remove Bypass" allows

monitoring the input point again (for a sensor

that is "OK").

____________________________________________

Output-Point Commands

(After right-clicking an Output/Device)

Also See: "Common Commands", previous/above.

--------------------------------------------------------------------------

Tips

: First, select "Manual Output Control".

Additional parameters appear when applicable

(duration, etc.).

- Normal: No manual control (i.e., return to

normal operation);

- Always: Allows setting the output as On

or Off

continuously (until manual control is removed);

- Momentary: Allows setting the output to

pulse/toggle once. Additional selections will

appear for:  Whether it is to be triggered On

(high), or Off (Low);  The state it will be left in

afterwards (Off

, On, or Normal);  How long the

relay will remain triggered (1 second to 1 week).

- Duty Cycle (1 sec. On/1 sec. off): The output

will be pulsed on and off continuously for a

selected duration (1 second to 1 week).

___________________________________________

Elevator Commands

(After right-clicking an Elevator)

Also See: "Common Commands", previous/above.

-------------------------------------------------------------------------

- Secure / Desecure: This allows applying or

removing controlled-access for all floors as

accessed from the specific elevator (lift).

(Secure: An access card or token provides access to

specific floors;  Desecure

: Anyone can access any

floor without a card or token.

Controlling a Floor (as accessed from all cabs): Refer

to "Checking Status or Controlling Floors"

Camera Status/Control and

Adjustments

Introduction

A number of camera controls are provided,

allowing you to:  Aim or zoom PTZ cameras;

 Check connection status;  Adjust image

quality, etc. These features are provided

through the video toolbar in each camera-