User`s guide

21-0381E v4.7.4
Welcome Report
Control Admin Sys Config Tech-Ref
71
Resetting Users'
Antipassback Status
Antipassback (APB)
: A feature that blocks
individual cards from being used to:
+ Re-enter the same area, or;
+ Re-enter the facility from 'outside', and/or;
+ (Optional): Enter other areas;
…Unless
they are recorded as exiting first--
i.e., each person must use their card/token
at every reader they encounter (that is set to
"Detect Antipassback"). Tip: This helps to
protect against unauthorized card usage.
Enabling the Antipassback Feature
: To
enable antipassback tracking for specific
areas and doors, refer to the "Antipassback"
selections under "Areas and Related
Settings", and the "Detect Antipassback"
selection under "Reader 1 & 2 Settings for a
Door".
Antipassback Reset
From time-to-time, a person may be
unable to enter a door due to an
antipassback violation (such as if
they entered or exited when the
system unlocked a door for someone
else).
This can be corrected by resetting the
antipassback status for the specific
user, or all users, as desired.
Reset APB Status by Area: You can also
reset user antipassback status on an area-
by-area basis. For details, refer to
"Checking Status or Controlling Items by
Area" (in a following section).
Resetting Antipassback Status
Initiate a connection with the panel(s), and
access the "System" Control & Status topic as
described previously/above.
Multi-Panel Systems: Select the desired panel at the
bottom of the form (if not shown/selected in the 'tree').
If the status screen is blank or inactive (or if you'd like
more information), refer to "Accessing the Control and
Status Topics for a Panel" (under "Checking Status &
Controlling Items", previous).
Then, click [Anti-Passback Reset]. In the
next screen, select an individual user, or "All
Users", and the panel(s) to be affected by the
reset (i.e., the ones associated with the
specific areas and doors).
When finished, click OK, and respond to any
additional messages that appear.
-Panel (bottom of the form): This is where you
select a desired panel (for systems with more
than one).
Control & Status Panel Control & Status
System (Antipassback)
Control & Status Panel Control & Status
System [Anti-Passback Reset]