User`s guide

82 Guardall Director V4.74 User's Guide 21-0381E v4.7.4
- Schedule-Related Items
(visible only for a
scheduled area)
: This shows schedule-related
status topics, and provides buttons to set/delay
the closing time [Work Late], or [Suspend] (or
Resume) the schedule (if you have the
authority).
- Door Reader Commands for all Doors of the
Area (3 buttons across the middle): Allows
controlling all
doors in the selected area (if you
have the authority).
[Lock All Doors]: This locks / re-locks all doors
pertaining to the selected area (i.e., all doors with one
of its readers set to this area);
[Unlock All Doors]: This unlocks all doors pertaining
to the selected area (i.e., all doors with one of its
readers set to this area);
[Advanced]: This button provides access to
additional reader/door commands. Selections include
unlock/relock the doors, lockout or reinstate card
access, and/or change various modes at the doors.
"Momentary" pertains to the defined "Unlock Duration"
(such as when a person uses their access card), and
"Pending" means the command will be held until after
one valid user gains entry at the door.
Reader commands pertain to all
readers that allow
entering (or remaining within) the specific area.
Readers that allow exiting from the area will be set to
either a different area, or "outside".
For details on the various reader modes, card modes,
and class map settings, refer to "Doors, Readers, and
Related Settings".
Elevator Readers
: These commands do not apply to
readers in elevator (lift) cabs. To control an elevator
and/or its associated reader, refer to "Checking Status
or Controlling Elevators".
- Door List: Shows the status of doors in the
area, and provides selections for unlocking or
relocking individual doors (if you have the
authority).
Pending Unlock: This is an "unlock" that waits until
someone gains entry at the specific door.
- Input Point List: Shows the status of input
points (sensors) in the area, and allows
bypassing individual sensors in each area (for
points that support this, and if you have the
authority).
The Door-List and Input-Point List are available only in
'forms' view (click Form on the toolbar to switch to
'forms' view).
Area Users (Activity, User Count,
and APB-Reset)
Control & Status - Area Users
The "Area Users" screen shows / allows:
 Whether or not activity has occurred in the
area.
(This is based on users entering or leaving the area,
and/or a custom 'Activity Monitor' input point being
tripped.)
 The number of users presently in the area;
 Whether or not the area is full (i.e., contains
the 'allowed' number of persons/vehicles).
 Allows resetting the 'user-count' as desired
(to min/empty, max. allowed, or any custom
value);
 Allows resetting the antipassback (APB)
status for all users in an area (see next
section)
.
Note: To be available here, the 'user-counting' and
'activity tracking' features must have been set up for the
specific area(s).
Ref: "Configuration Areas" (Counting; Activity).
Working with this Screen
 Ensure you are connected with the specific
panel(s) as described previously.
 Open the Area Users screen:
MyTools Bar: Control & Status - Area Users
Tree
: Control & Status, Panel Control & Status,
Areas, Area Users
 Use the Grid / Form toolbar-button to select
your preferred view-mode;
 Refer to the selection-descriptions for this
screen while viewing the status topics for
items in the desired area.