User's Manual

21/33
üü To enable the keypad tones, press the FUNCTION key “FNC”, “3”
again.
Sending DTMF Tones
üü From the Keypad:
Press any key “0” through ”9”,”*” and “#” to send the DTMF tones
during conversation mode.
üü From a memory location:
Press “RCL” and “*” , then up arrow, down arrow, or numeric
entry(or M1 key) to select a memory location. When desired
number is displayed, press “SEND”, and DTMF digits will be sent.
The DTMF tone will be heard in conjunction with the telephone
number recalled and displayed.
!
Recalling numbers in DTMF mode is not possible while
DTMF Mute is active.
u Timer and Counter Functions
Elapsed Time Display
While the IN USE indicator INUSE is lit, the clock in the display panel
will keep a running total of elapsed time from the time of connection for
that call in minutes:second format. After call completion, this function
will display the total elapsed time (spent on-line) of the last call made.
üü To display the elapsed time in the display panel, press the
FUNCTION key “FNC”, “*”, “3”,”0”. The word “Air” will appear in the
display panel.
!
The time count will reset to 00-00 after 99 minutes and 59
seconds.
!
When the call time is displayed using “FNC”,”*”,”3”, “0”,
the time display does not reset until 9999 minutes and 59
seconds.
Outgoing Call Timer
This function is used to time your outgoing calls. The timer resets to
0000:00 after 9999 hours and 59 minutes.
üü To display the value for outgoing call times, press “FNC”, “*”, “3”,
“1”, then enter the registered two-digit Outgoing Call Timer access
code.
üü To manually reset the Outgoing Call Timer to 0000:00, press “*”,
“CLR”.
üü To exit this mode, press the CLEAR key “CLR”.