User's Guide

12/4140
When entering telephone numbers manually, each digit
entered will appear in the display panel and will scroll from
right to left every time a new digit is entered.
üü To place a call, make sure the power is on (refer to the
“Turning the Phone ON” on previous page), enter the
desired telephone number and press “SEND”. At this
point, the IN USE indicator will light and the dialing
sequence will be executed.
üü To correct an error made while entering a telephone
number, use the following methods:
l Press the CLEAR key
CLR
to erase the last digit
entered.
l Press and hold the CLEAR key
CLR
to erase all the
digits in the display.
l Press “END”
END
momentarily to erase all the digits
in the display.
üü To cause an on-hook condition after or during the
dialing procedure, just press “END”.
!
The display panel has a 15 digit capacity.
However, numbers containing up to 32 digits
may be entered, therefore only the last 15 digits
dialed will remain in the display.
Refer to the part in this section entitled
“Reviewing the Preceding Digits”
Receiving Calls
The cellular phone features both audio and visual signals to
indicate an incoming call.
The telephone will both ring and the word “CALL” will
flash repeatedly in the display panel.
üü To answer an incoming call when the handset is resting
in its cradle, simply lift the receiver. The ringing will