Operation Manual
19
English
as when switched-o. The hands-free funcon cannot be used when it
is turned o.
7 Connecng via Bluetooth
Ensure the headset is switched o rst. Press and hold the on/o buon
for about 6 seconds ll the LED indicator starts to ash in red and blue
alternately. Enable the Bluetooth on the device that you want to connect
with the headset. Carry out a search now and connect to the device "CSL-
450". Enter "0000" if you are prompted for a security code.
Note: The Bluetooth pairing mode is disabled for security reasons if con-
necon is not established even aer several minutes. Please carry out the
steps menoned above once again if pairing failed.
Please proceed as follows to connect two devices at the same me to
your CSL-450 headset: Connect your rst device to the CSL-450 headset
as usual. Then press the "Increase volume" and "Decrease volume" but-
tons simultaneously to use the funcon for connecng the headset to
two devices. Then, search for the model "CSL-450" on your Bluetooth en-
abled device. Here, the device that was paired rst always has priority. If
it is disabled, then you can also make phone calls or play music with the
second device.