User's Manual
Use keys to open and lock tablet enclosure.
3. Stand Assembly:
4. Connecting the Gooseneck Enclosure & Battery Case
1. Insert the pole into the center of the heavy duty base.
2. Place metal washer over tightening screw rod, then screw into the
bottom side of the stand base center, turning clockwise to tighten.
Gooseneck
Metal
Connection
2.Place gooseneck over metal connection
then turn clockwise to screw down until tight.
METAL CONNECTION
HEAVY DUTY BASE
HEIGHT
ADJUSTMENT
KNOB
POLE
METAL WASHER &
TIGHTENING SCREW ROD
Attaching wheels:
Connect wheels to stand base before attaching pole.
Screw wheels into floor base by hand,
then use wrench to tighten.
Star Allen Key
3.Use the smaller Star Allen key to tighten the
small star meter screw inside the gooseneck.
Note: if meter screw is already in, unscrew
before attaching gooseneck in step 2.
Battery Case
PAD-HSFK10
1. Place battery case over metal
connection on the pole.
iPad 10.2”
iPad Gen. 7(iPad 10.2”)
iPad Pro 10.5”
iPad Air 3.
Heavy-Duty Security Floor Stand
for iPad Gen. 7(iPad 10.2”),iPad Pro 10.5” & iPad Air 3
Instructions：
1. Installing your Device into the Tablet Enclosure
Clockwise for locking,counter-clockwise
for unlocking.
5. Installing your Device and Adjusting the Floor Stand:
2. Rotate plastic grip to adjust pole to desired height.
Flex the gooseneck freely to adjust your favorite view
angle.
1.Use included Allen key to tighten and loosen the gooseneck
to holder connection screw to adjust ease of rotation.
Insert key into lock at enclosure rear.
Turn counter-clockwise to unlock.
Insert tablet and route charge cable with
the cable managment system through the
cutout at the rear.
Shut the enclosure and turn key clockwise
and remove to lock.
2.Going the Cable Through the Cable Routings on the Pole
1.Put the top pole to the lowest position,insert the cable into the cable routing on the bottom pole and push inward.
2.Draw out the top pole and continue to push inward the cable until the cable head is visible through the cable routing on the top pole .
3.Draw out the cable head from the cable routing on the top pole .
This product allows you to go through the cable from the cable routings on the pole.
Allen Key
270
rotation
o
360 rotation
o
Stick the attached thin round pad on
each of the round pad to ensure the
perfect fit for iPad 10.5”.
**Note - Hinges may get looser and droop over time. Please tighten screws for optimum usage and eciency.