Instruction Manual

ManualsBrandsCTA Digital ManualsFloor StandCTA Digital PAD-SHFS Heavy-Duty Medical Mobile Floor Stand

for 7-13 Inch Tablets

PAD-SHFSW

Heavy-Duty Medical Mobile Floor Stand (White)

Instructions:

Package Contents:

1.Unlock the Security Holder

The optional foam pads(1,5,10,15mm)

allow you to install your tablet with or

without a case

2.Isert the key into the lock slot.

3.Press and hold on the release button

to unlock the holder.

1mm 5mm

10mm 15mm

1.Select and stick on the correct foam pad according to the thickness of your tablet.

Foam Pads

1mm 5mm 10mm 15mm

2.Going the Cable Through the Cable Routings on the Pole

1.Put the top pole to the lowest position,insert the cable into the cable routing on the bottom pole and push inward.

2.Draw out the top pole and continue to push inward the cable until the cable head is visible through the cable routing on the top pole .

3.Draw out the cable head from the cable routing on the top pole .This product allows you to go through the cable on the top of the gooseneck.

This product allows you to go through the cable from the cable routings on the pole and gooseneck.

3.Stand Assembly:

4.Connecting the Gooseneck Tablet Holder

1. Insert the pole into the center of the heavy duty base.

2. Place metal washer over tightening screw rod, then screw into the

bottom side of the stand base center, turning clockwise to tighten.

2. Turn clockwise to screw down until tight.

METAL CONNECTION

HEAVY DUTY BASE

HEIGHT

ADJUSTMENT

KNOB

POLE

METAL WASHER &

TIGHTENING SCREW ROD

Attaching wheels:

Connect wheels to stand base before attaching pole.

Screw wheels into floor base by hand,

then use wrench to tighten.

3.Use the smaller Allen key to tighten the

small meter screw inside the gooseneck.

Note: if meter screw is already in, unscrew

before attaching gooseneck in step 2.

1. Place the gooseneck over metal

connection on the pole.

5. Installing your Device and Adjusting the Tablet Holder

Press and hold on the release button to unlock the

holder,place tablet against corner then slide in

until snug.

2. Use Allen key to adjust tension at point of

connection between the tablet holder and

gooseneck,flex the gooseneck to adjust the view

angle according to your needs.

Allen Key

360 rotation

270

rotation

Multi

direction

flexing

3. Rotate plastic grip counter-clockwise

to loosen, then adjust pole to desired

height. Rotate plastic grip clockwise to

tighten.

Tablet

Gooseneck

Metal

Connection

Allen Key