Quick Start Guide

Heavy Duty Security Station for Laptop-Tablet Hybrids

2. Package contents:

(1) Left Rack

(1) Left Clip

(2) Hand-Turn Screws

(1) Security Cable

(1) Right Rack

(1) Right Clip

(1) Push-in Lock

(2) Keys

(1) Set of Optional

Mounting Screws

3. Operation Instructions: 4. Optional Mounting Kit

A. Locking:

1. Loop the cable around an immovable object. (Figure 1)

2. Separate the left and right racks. (Figure 2)

3. Connect the right clip with the right rack and affix with Hand-Turn

Screw. (Figure 3)

4. Connect the left clip with left rack and affix with Hand-Turn Screw.

(Figure 4)

5. Attach cable loop to shaft. (Figure 5)

6. Connect racks together and place laptop inside. (Figure 6)

7. Push left rack in until the clamp clips around the laptop. (Figure 7)

8. Press lock in to lock. (Figure 8)

B: Unlocking

1. Insert key to unlock. (Figure 9)

2. Pull left rack out and remove laptop. (Figure 10)

Install with this mounting bracket if you do not wish to

use the security cable.

1. Use screws to attach bracket to desk or table top.

(Figure 11)

2. Slide shaft through arcs of the bracket. (Figure 12

and 13)

3. See previous section for setup instructions.

Figure 1

Figure 2

Figure 3 Figure 4

圖三

1. Overview

PAD-SSLT

PAGE 1
Heavy Duty Security Station for Laptop-Tablet Hybrids PAD-SSLT 1. Overview Figure 1 Figure 2 Figure 3 Figure 4 圖三 2. Package contents: (1) Left Rack (1) Left Clip (2) Hand-Turn Screws (1) Security Cable (1) Right Rack (1) Right Clip (1) Push-in Lock (2) Keys (1) Set of Optional Mounting Screws 3. Operation Instructions: A. Locking: 1. Loop the cable around an immovable object. (Figure 1) 2. Separate the left and right racks. (Figure 2) 3.
PAGE 2
Figure 5 Figure 6 Figure 10 Figure 7 Figure 11 SUCTION CUP LOCK FOR LAPTOP/TABLET HYBRIDS 1. After Step 5 in the Operation Instructions, slip the suction lock ring over the back rod (Figure 14). Figure 14 2. Insert tablet and slide other bracket end over metal rods. Pull back the curved tab on the suction lock and press firmly against back of laptop screen (Figure 15). 3. Push curved tab in, then attach combination lock in lock hole, then continue to Step 6 in Operation Instructions (Figure 16).