Use and Care Manual

Instructions:
1. Stand Assembly:
1. Put the battery case and goose-neck to
the top of the metal connection.
2. Connecting the Tablet gooseneck holder
1. Insert the pole into the center of the heavy duty base.
2. Place metal washer over tightening screw rod, then screw into the
bottom side of the stand base center, turning clockwise to tighten.
Gooseneck
Metal
Connection
2.Screw up the goosenck to hold the battery
case .
-
METAL CONNECTION
HEAVY DUTY BASE
HEIGHT
ADJUSTMENT
KNOB
POLE
METAL WASHER &
TIGHTENING SCREW ROD
Attaching Wheels:
Connect wheels to stand base before attaching pole.
Screw wheels into floor base by hand, then
use wrench to tighten.
Smaller Allen Key
2.Screw up the small meter screw inside the
gooseneck to tighten the connection by the
Smaller Allen Key.
Battery Case
3. Rotate plastic grip counter clock
wise to loosen, then adjust pole to
desired height. Rotate plastic grip
clockwise to tighten.
1. Press the button on the side of the
holder center to slide out holder arm.
Insert your tablet against the spring
end, then slide the other arm back in,
closing firmly.
2. Tighten and loosen the gooseneck to
holder connection screw to adjust ease of
rotation.
3. Installing your Device and Adjusting the Floor Stand:
Bigger
Allen Key
Heavy-Duty Gooseneck Floor Stand
for 7-13 Inch Tablets
PAD-HFS
[e-mail]