User manual

Chapter 1 Introduction
10
1.7 Line Card Specifications
1.71 FIB1-10/100
The FIB1-10/100 line card is an Ethernet Fiber Media Converter that is compliant
with IEEE802.3 10Base-T, IEEE802.3u 100Base-TX and 100Base-FX Ethernet. The
10/100Base RJ-45 connectors are all located on the front panel of the FIB1 card. One
RJ-45 connector is provided for each interface converter. All connections are
designed as auto MDI-X type, requiring only a straight connection to any device. A
unique feature of the FIB1-10/100 converter is the use of a common PCB card which
may either be used as a standalone converter (FIB1 series) or placed in the FRM301
rack.
RJ-45 Pin MDI-X type MDI type
1 Rx+ Tx+
2 Rx- Tx-
3 Tx+ Rx+
6 Tx- Rx-
10Base-T UTP Cable Requirement
Cable type: Category 3, 4 or 5. Maximum cable distance: 100 meters (328 feet)
100Base-TX UTP Cable Requirement
Cable type: Category 5. Maximum cable distance: 100 meters (328 feet)
1.72 FIB1-1000
The FIB1-1000 line card is an Ethernet Fiber Media Converter that is compliant
with IEE802.3z 1000BASE-TX or Gigabit Ethernet and 1000Base-SX/LX Gigabit Fiber.
One RJ-45 connector is provided for connection to either MDI-X (To PC) or MDI (To
HUB) equipment. Utilizing Auto MDI/MDIX allows all UTP connections to be made
using only a common straight-through UTP cable. A unique feature of the FIB1-1000
converter is the use of a common PCB card which may either be used as a standalone
converter (FIB1 series) or placed in the FRM301 rack. This converter may force full or
half duplex mode on the fiber port.
RJ-45 Pin 568-A type 568-B type
5 Pair1-Tip Pair1-Tip
4 Pair1-Ring Pair1-Ring
3 Pair2-Tip Pair3-Tip
6 Pair2-Ring Pair3-Ring
1 Pair3-Tip Pair2-Tip
2 Pair3-Ring- Pair2-Ring
7 Pair4-Tip Pair4-Tip
8 Pair4-Ring Pair4-Ring
1000BASE-TX UTP Cable Requirement
Cable type: 1000Base-TX; 4 pair , Cat. 5 or 6, EIA/TIA-568, STP/UTP
Maximum cable distance: 100 meters (328 feet)