User manual

Chapter 3 Management System

Menu System Detail

To enter "terminal mode", a password may be required. Normally, there is no password set

from the factory. The superuser password for the "terminal mode" is "1021". The user

password provides security to protect the system. From a Telnet connection, if you enter the

wrong password three times, the security system will not allow any login again for 15 minutes.

After entering the correct password, you will see the main menu display on the screen as

follows :

**************************************************************

*** CTC UNION TECHNOLOGIES CO., LTD V4.06 -17[Oct. 28th] ***

*** FRM-301 Fiber Optical Media Converter Rack Management ***

**************************************************************

Main Menu and Rack Status:

1:Slot #1 >> 10/100 Base << || 9:Slot #9 >> 10/100 Base <<

2:Slot #2 >> 10/100 Base << || A:Slot #10 >> 10/100 Base <<

3:Slot #3 >> E1 BNC << || B:Slot #11 >> 10/100 Base <<

4:Slot #4 >> E1 BNC << || C:Slot #12 >> 10/100 Base <<

5:Slot #5 >> SERIAL << || D:Slot #13 >> 10/100 Base <<

6:Slot #6 >> SERIAL << || E:Slot #14 >> 10/100 Base <<

7:Slot #7 >> V.35 << || F:Slot #15 >> 1000E <<

8:Slot #8 >> V.35 << || G:Slot #16 >> 1000 Base <<

Command Function Key:

'1' to '9', 'A' to 'G': I/O Cards Setting

'P': Show Fans and Powers Status

'R': Refresh Status

'ESC' Logout

'M': Manager Configuration Setup

'S': System Configuration and TFTP Setup

Console:[On line] Telnet:[Off line] GUI:[Off line]

The card status of all slots in the rack is shown. If a valid card is found in the slot,

the slot status will identify the card. If no card is found, the slot status will display

"Empty". As we can see in the above example, sixteen cards are inserted in the rack.

No card slots are empty. The immediate, 'Command Function', shown in the middle

of the display, is to display the status of the I/O cards. The cards are number 1~16,

right to left and can be selected with single keyin of 1~9 or A~G. Remember, cards

are numbered right to left from the FRONT of the chassis. Pressing the card number

will immediately display card's status. The other function keys are explained below.

P: this key will immediately display the status of the power supplies and all fans.

R: this key will refresh the display.

ESC: the escape key will logout of the terminal mode.

M: the 'M' key will enter the Manager Configuration screen, where the manager

workstation IP is configured and the trap destinations may be setup.

S: the 'S' key enters the System Configuration screen, where the SNMP card's

networking settings are configured.

The console line displays the connected status of any Telnet or GUI session.

version meaning: SNMP 4.06, CPU 2.17