User manual

Chapter 3 Management System

10/100Base Line Card Detail

The following is the display screen for a 10/100Base Ethernet fiber converter.

**************************************************************

*** CTC UNION TECHNOLOGIES CO., LTD V4.06 -17[Oct. 28th] ***

*** FRM-301 Fiber Optical Media Converter Rack Management ***

**************************************************************

Slot #01 10/100 Base Card Status:

Ethernet >> Link Up <<

Fiber >> Link Up <<

Card Parameter Setup Menu:

0: Channel Enable/Disable >> Enable <<

1: UTP Speed >> 100Base-T(Auto)<<

2: UTP Tx/Rx Mode >> Full-D(Auto) <<

3: UTP Negotiation Mode >> Auto <<

4: Fiber Tx/Rx Mode >> Full-Duplex <<

5: LLF Function >> Disable <<

6: Remote Loop Back Test >> <<

7: Get Remote (CPE) Data

8: Reset Channel Setting to Default

Command Function Key:

'0' to '5': Toggle I/O Card Settings

'6' to '8': I/O Card Commands

'R': Refresh Status

'ESC': Main Menu

The following are descriptions of the function keys available and the actions

which they perform.

0: This key toggles the channel enable/disable and can be used to halt

transmission on this line card to the remote cpe side.

1: In manual mode, this key toggles between 10Base-T and 100Base-TX Ethernet.

2: In manual mode, this key toggles between Full and Half duplex Ethernet.

3: This key toggles between manual mode setting and auto negotiation of

Ethernet.

4: This key toggles between Full and Half duplex mode on the fiber (FX) side.

5: This key toggles the Link Loss Forwarding function enabled or disabled.

6: This key initiates the remote loop back test.*

7: This key initiates the get remote status function.*

8: This key will reset the card settings to factory default.

R: This key will refresh the screen display.

ESC: This key will leave the card setting menu.

* During Get Remote CPE and/or loop back tests, normal traffic is interrupted.

Link statuses

current

settings