User manual

Chapter 3 Management System

1000Base Line Card Detail

The following is the display screen for a 1000Base Ethernet fiber converter.

**************************************************************

*** CTC UNION TECHNOLOGIES CO., LTD V4.06 -17[Oct. 28th] ***

*** FRM-301 Fiber Optical Media Converter Rack Management ***

**************************************************************

Slot #16 1000 Base Card Status:

Ethernet >> Link Up <<

Fiber >> Link Up <<

Card Parameter Setup Menu:

0: Channel Enable/Disable >> Enable <<

1: Fiber/UTP Tx/Rx Mode >> Full-Duplex <<

2: LLF Function >> Disable <<

3: Remote Loop Back Test >> <<

4: Get Remote (CPE) Data

5: Reset Channel Setting to Default

Command Function Key:

'0' to '2': Toggle I/O Card Settings

'3' to '5': I/O Card Commands

'R': Refresh Status

'ESC': Main Menu

The following are descriptions of the function keys available and the actions

which they perform.

0: This key toggles the channel enable/disable and can be used to halt

transmission on this line card to the remote cpe side.

1: This key toggles between Full and Half duplex mode on the fiber (FX) side.

2: This key toggles the Link Loss Forwarding function enabled or disabled.

3: This key initiates the remote loop back test.*

4: This key initiates the get remote status function.*

5: This key will reset the card settings to factory default.

R: This key will refresh the screen display.

ESC: This key will leave the card setting menu.

* During Get Remote CPE and/or loop back tests, normal traffic is interrupted.