User manual

Chapter 3 Management System

E1 / T1 Line Card Detail

The following is the display screen for the E1 BNC fiber converter.

Slot #03 E1 BNC Select Menu:

Select Menu:

1: Local Setting

2: Remote Setting

Command Function Key:

'1' to '2': Select Menu

'ESC': Main Menu

The E1 / T1 card supports remote management features; Select 1 or 2.

Slot #03 E1 BNC Card Status:

E1 >> Link Up << H/W Version: 1.1

E1 AIS >> Off << F/W Version: 1.1

Fiber >> Link Up <<

Test LED >> Off <<

Card Parameter Setup Menu:

0: Channel Enable/Disable >> Enable <<

1: Far End Fault Setting >> Disable <<

2: AIS Setting >> Disable <<

3: Line Code >> HDB3 <<

4: Port Reset >> Disable <<

5: E1/T1 Loop-Back test >> Off <<

6: Fiber Loop-Back test >> Off <<

7: Reset Channel Setting to Default

Command Function Key:

'0' to '4': Toggle I/O Card Settings

'5' to '7': I/O Card Commands

'R': Refresh Status

'ESC': Previous Menu

The following are descriptions of the function keys available and the actions

which they perform.

0: This key toggles the channel enable/disable and can be used to halt

transmission on this line card to the remote cpe side.

1: This key toggles the FEF setting enabled or not.

2: This key toggles the AIS; normal condition should disabled.

3: This key toggles between AMI and HDB3 (BZ8S for T1) Line coding.

4: This key toggles the Port Reset.

5: This key initiates the E1 remote loop back test.*

6: This key initiates the Fiber remote loop back test.*

7: This key will reset the card settings to factory default.

R: This key will refresh the screen display.

ESC: This key will leave the card setting menu.

* During loop back tests, normal traffic is interrupted.