User manual

Chapter 3 Management System

Serial Line Card Detail

The following is the display screen for the Serial fiber converter.

Slot #05 SERIAL Select Menu:

Select Menu:

1: Local Setting

2: Remote Setting

Command Function Key:

'1' to '2': Select Menu

'ESC': Main Menu

The Serial card supports remote management features; Select 1 or 2.

Slot #05 SERIAL Card Status:

Data In Status >> Mark << H/W Version: 1.0

Fiber >> Link Up << F/W Version: 1.0

Test LED >> Off <<

Card Parameter Setup Menu:

0: Channel Enable/Disable >> Enable <<

1: Far End Fault Setting >> Disable <<

2: Port Reset >> Disable <<

3: Mode Setting >> RS-232 3 Wire <<

4: SERIAL Termination >> Disable <<

5: Fiber Loop-Back test >> Off <<

6: Reset Channel Setting to Default

Command Function Key:

'0' to '4': Toggle I/O Card Settings

'5' to '6': I/O Card Commands

'R': Refresh Status

'ESC': Previous Menu

The following are descriptions of the function keys available and the actions

which they perform.

0: This key toggles the channel enable/disable and can be used to halt

transmission on this line card to the remote cpe side.

1: This key toggles the FEF setting enabled or not.

2: This key toggles the Port Reset.

3: This key toggles between the different mode settings for RS-232,485, and 423.

4: This key toggles the setting of termination for the serial interface lines.

5: This key initiates the fiber remote loop back test.*

6: This key will reset the card settings to factory default.

R: This key will refresh the screen display.

ESC: This key will leave the card setting menu.

* During loop back tests, normal traffic is interrupted.