User manual

Chapter 4 GUI Software

4.33.2 Ethernet Line Card Settings

Click the button marked "Chx". From the Card Setting window we can display

the individual line card's status, setup the card's working status, configure the UTP

and fiber modes, get the remote unit's status or do loop back functions. Use the "Get"

button to read the card's status. Use the "Set" button to write new status to the card.

(The operations are all preformed via SNMP protocol.)

Figure 4.19 Ethernet Line Card Settings

The card slot, type, address of machine and machine type are shown in the

header information. The 'Command Set' window is used for channel enable/disable,

UTP mode setting, Fiber mode setting, LLF function enable/disable, and normal or

extended packet frame length setting. The settings may be 'Set ToDefault' or 'Read'

from the current card settings. Once the radio buttons are chosen the single card is

set by the 'Modify' button or all same type cards can be set identically by clicking the

'Modify All' button.