User manual

Chapter 4 GUI Software
81
4.33.4 Gigabit Ethernet Line Card Settings
Click the channel button for a 1000Base line card to view and configure the local
line card. Under the GUI, the card's status, Tx/Rx Duplex mode and LLF function
may be read or modified.
Figure 4.22 Gigabit Line Card Settings
The functions are very similar to those of the 10/100 Ethernet converter. Note
the 'Command Set' can only enable / disable the channel, set the fiber full or half
duplex, and enable/disable the Link Loss Forwarding function. When connected to
an FIB1-1000, the loop back and get remote status functions may be used as well. The
display example shows a connected FIB1-1000 card.