User manual

Chapter 4 GUI Software
85
4.33.7 DATA Line Card Settings
If a DATA Line Card is installed in any slot, the status of the serial interface link,
port settings and loop back functions may be viewed by clicking the channel button.
Use the 'Get' button to read settings and the 'Set' button to send any modifications to
the line card.
Figure 4.27 DATACOM Line Card Settings
The command sets may be performed on the local converter in the rack or on the
remote FIB1-Data fiber converter. The LEDs show the real time status of the card and
remote converter. Both the local and remote status and settings are displayed. A full
set of loop back functions are available for both the Datacom or the fiber line.
After modifying any function in the GUI, click the 'Set' button to send the
changes, via SNMP protocol, to the managed device. Click the 'Get' button to update
the display readings.
Refer to Chapter 3 for detailed meanings of all the configuration settings.