User manual

Appendix A
43
LED Status Indicators
LED Function State Status
PWR Power indicator On Converter has power.
Off Converter has no power or has been disabled.
Blinking Card is being upgraded.
FEF Far End Fault On Indicates some fault condition from the unit connected on the remote fiber
Off Normal no fault condition
FX Link Fiber link On The fiber link is ok.
Off No link or the link is faulty.
Blinking Receiving data on the fiber.
100 mode display On UTP side is operating in 100Mbps mode.
Off UTP side is operating in 10Mbps mode
Full mode display On UTP side full duplex mode (20/200mbps).
Off UTP side half-duplex mode (10/100mbps).
TX Link Ethernet link On The UTP link is ok.
Off No link or the link is faulty.
Blinking Receiving data on Ethernet.
The 10/100Base RJ-45 connector is located on the front panel of the line card. One RJ-45 connector is provided
for each interface converter. All connections are designed for auto MDI-X operation, requiring only a straight
connection to any device. A unique feature of the FRM220-10/100i converter is the use of a common PCB card
which may either be used as a standalone converter (FRM220-Ch01 series) or placed in the FRM220-Ch20 rack.
Configuration
From the main menu of the FRM220 NMC console, select the slot number containing the 10/100i line card.
****************************************
*** CTC UNION TECHNOLOGIES CO., LTD. ***
*** FRM220 NMC VER. 1.02 ***
****************************************
This Chassis ID:[00] Cascaded:[Yes] Monitored Chassis ID:[00]
SLOT #02 > FRM220-10/100I [Local ] [ Ver:1.100-1.000-0.000-0.000 ]
<1>: Port Active:[Enable ]
UTP Link:[Up ] Rx Active:[On ]
<2>: Negotiation:[Auto ]
<3>: Speed: [100 ]
<4>: Duplex: [Full]
FX Link:[Up ] Rx Active:[On ] FEF:[Off ] Remote PWR:[OK ]
<5>: Loop Back Test:[Off ] Status:[----]
<6>: Operation Mode: [Switch ]
<7>: Ingress Rate Limit(IRL) Mode: [No Limit] [100.0M]
<8>: Egress Rate Limit(ERL) Mode: [No Limit] [100.0M]
<9>: Link Fault Pass Through(LFP): [Disable]
<A>: Auto Laser Shutdown(ALS): [Disable]
<B>: Send Remote Hardware Reset
<C>: Port Reset
Digital Diagnostic(D/D) Function:[Yes]
<D>: Go to the D/D Functions menu. <N>: Go to the Remote menu.
<ESC>: Go to previous menu. Please select an item.
<1> When the port is disabled, the PHY becomes inactive and all Ethernet traffic will be blocked.
<2> <3> <4> Control the auto-negotiation (n-way) and forced mode Ethernet settings.
<5> Performs an OAM loop back test, non-intrusive to client's transmitted data.
<6> Configures the MC between either switch mode (store & forward) or converter mode (cut-thru).
<7> Sets a rate limit on packets passing from UTP to Fiber in either multiples of 32K or 512K
<8> Sets a rate limit on packets passing from Fiber to UTP in either multiples of 32K or 512K
<9> Enable or disable the LFP function
<A> Enable or disable the Auto Laser Shutdown (ALS) function.
<B> Send hardware reset to remote unit via fiber (must enable reception from the remote side)
<C> Performs a reset on the port.
<D> View the transceiver's digital diagnostics (DD) if available.
<N> Go to manage the remote via OAM.