User manual

Appendix A

Below is an example of managing the remote MC via OAM.

****************************************

*** CTC UNION TECHNOLOGIES CO., LTD. ***

*** FRM220 NMC VER. 1.02 ***

****************************************

This Chassis ID:[00] Cascaded:[Yes] Monitored Chassis ID:[00]

SLOT #02 > FRM220-10/100I [Remote] [ Ver:1.100-1.000-0.000-0.000 ]

Port Active:[Enable ]

UTP Link:[Up ] Rx Active:[On ]

<2>: Negotiation:[Auto ]

<3>: Speed: [100 ]

<4>: Duplex: [Full]

FX Link:[Up ] Rx Active:[On ] FEF:[Off ] Remote PWR:[OK ]

<5>: Loop Back Test:[Off ] Status:[----]

<6>: Operation Mode: [Switch ]

<7>: Ingress Rate Limit(IRL) Mode: [No Limit] [100.0M]

<8>: Egress Rate Limit(ERL) Mode: [No Limit] [100.0M]

<9>: Link Fault Pass Through(LFP): [Disable]

<A>: Auto Laser Shutdown(ALS): [Disable]

<B>: Accept Remote Hardware Reset: [Disable]

<C>: Port Reset

Digital Diagnostic(D/D) Function:[Yes]

<D>: Go to the D/D Functions menu. <N>: Go to the Local menu.

<ESC>: Go to previous menu. Please select an item.

When managing from the remote, the port cannot be disabled. To do so would put it to sleep forever as it can not be awoken by

any OAM command once the fiber is down. Therefore, no option is provided in the remote.

<2> <3> <4> Control the auto-negotiation (n-way) and forced mode Ethernet settings.

<5> Performs an OAM loop back test, non-intrusive to client's transmitted data.

<6> Configures the MC between either switch mode (store & forward) or converter mode (cut-thru).

<7> Sets a rate limit on packets passing from UTP to Fiber in either multiples of 32K or 512K

<8> Sets a rate limit on packets passing from Fiber to UTP in either multiples of 32K or 512K

<9> Enable or disable the LFP function

<A> Enable or disable the Auto Laser Shutdown (ALS) function.

<B> Enables reception of remote reset code from the local side.

<C> Performs a reset on the port.

<D> View the transceiver's digital diagnostics (DD) if available.

<N> Go to manage the local (in chassis) MC.