User manual

Appendix A
66
DSR constantly ON, except during tests
DCD constantly ON, except during signal loss
Test Loops LLB (Local Loop Back)
RLB (Remote Loop Back)
ITU-T V.54
Optical Specifications
Connector Type ST,SC,FC,LC,MT-RJ or WDM(single fiber) connectors.
Optical mode Multi-mode or Single-mode
Wave length 1310nm,1550nm
Power Margin 11dB(2Km,M/M) ,12dB~ 35 dB(15 ~ 120Km,S/M)
Data rate 40.32Mbps
Line coding Scrambled NRZ
Bit Error Rate Less than 10
-11
Environmental
Power consumption <4W
EMI FCC Class A, CE (EN55022), (EN60950)
Dimensions: 122.6 x 85.6 x 20 mm (H x W x D)
Weight 11 Oz (340g)
Temperature 0 - 50
o
C (Operating)
0 - 70
o
C (Storage)
Humidity 20 - 80 % non-condensing (Operating)
10 - 90 % (Storage)
Data Line Card Detail
The following is the display screen for the Serial fiber converter.
Slot #07 V.35 Select Menu:
Select Menu:
1: Local Setting
2: Remote Setting
Command Function Key:
'1' to '2': Select Menu
'ESC': Main Menu
The Data card supports remote management features; Select 1 or 2.
Slot #07 V.35 Card Status: page:1/2
TD >> Flash << | CTS >> Space << H/W Ver: 1.0
RD >> Flash << | RTS >> Space << F/W Ver: 1.1
| DCD >> Space <<
Fiber >> Link Up << | Test LED >> Off <<
Card Parameter Setup Menu:
0: Channel Enable/Disable >> Enable <<
1: Far End Fault Setting >> Disable <<
2: Port Reset >> Disable <<
3: Data Rate group Setting >> N*64K <<
4: Timing mode select >> Recovery <<
5: Data Rate Setting >> 1984K <<
6: Reset Channel Setting to Default
Command Function Key:
'0' to '5': Toggle I/O Card Settings
'6': I/O Card Commands
'R': Refresh Status 'N': Next Page
'ESC': Previous Menu
The following are descriptions of the function keys available and the actions which they perform.
0: This key toggles the channel enable/disable and can be used to halt transmission on this line card to the
remote cpe side.
1: This key toggles the FEF setting enabled or not.
2: This key toggles the Port Reset.
3: This key toggles the rate group setting between Nx64 or low speed.
4: This key toggles the timing mode between internal, external or recovery.
5: This key calls up the rate menu, where data rate is selected.