User manual

Chapter 3 Provisioning
32
3.2.10 SNMP management
CTC Union's ET100R router module provides SNMP management functions via standard MIB-II (RFC1213).
3.2.10.1 Deployment procedures
1. Review the basic routing function deployment in ET100R router module.
2. SNMP management configuration
CLI commands: (must be in enable)
config snmp on
config snmp read_only_community public *
config snmp read_write_community secret **
config save
* 'public' is typically the default community string for read only access to the SNMP.
** 'secret' is an example for the read/write community string. Use this string as your password for SNMP and don't use
the 'public' community string for read/write as it may present a security risk.
3.2.11 Resetting the ET100R to factory default
CTC Union's ET100R router module may be reset completely to the original factory configuration by either
hardware or software. The hardware method must be used if console password is forgotten and the unit cannot be
accessed. Software reset can be performed via CLI command (must be in enable).
1. Hardware Reset
Locate the reset push button switch on the rear panel of the ET100R router. With the unit powered off, press and hold
the reset switch. Power on the unit and continue to hold the reset switch for at least 8 seconds. Release the switch and
wait for the router to fully boot.
2. Software Reset
CLI commands: (must be in enable)
reset
All the current system configuration will be reset to default
Do you want to reset? (y/n) y
Reset system configuration to manufactory default...
3. Soft Reboot
CLI commands: (must be in enable)
reboot
Note: Be careful, there is no further confirmation, the router will immediately reboot.