Specifications

12
High speed coin counting operation instructions
How to replace the V-belt
§ Open the upper cover, pull the Front
Feed Pulley Arm upward, then remove
the V-Belt 322 and V-belt 564 from the
machine, then, put on a new V-Belt on
the Pulleys.
§ The tension of the Feed Belt can
be adjusted by adjusting the position
of the nutj.
§ The height of the Front Feed Pulley can
be adjusted by adjusting the position
of screwj.
§ The height of the Rear Feed Pulley can
be adjusted by adjusting the position
of the screwk.
§ Then tighten the nutj, nutk & nutl.
§ Remove the Rubber Washer on the
Plastic Pedal; unscrew the four screws
in the Plastic Pedal.
§ Unscrew the screw 1 and screw 2, rotate
the Coin outlet Chute, then you can
screw off it from the machine.
§ Pull the Bottom Cover upward; remove
the Bottom Cover from the machine.
§ Remove the V-belt 350 and fix a new
belt on the pulley, the tension can be
adjusted by adjusting the position of
the Pressure Roller Base.
*** In the interests of our policy of continual product improvement, specifications are
subject to change without notice ***