Network Router User Manual

Part Number 91-007-02
4
Figure 2
2.3 Lights
The Series 4100E SkyRouter has indicators as shown in Figure 1.
The network status indicator should be interpreted as follows:
NO IP CONNECTION
- When there is no connection, the led will be in the off state. If there is low signal (less than -
88dBm) you will see one 200msc blink (on) every 4.5 seconds. if there is good signal quality, you will see two 200msc
blinks (on) every 4.5 seconds.
IP CONNECTION
- If there is a connection, the led will be in the on state. If there is low signal, you will see one 200msc
blink (off) every 4.5 seconds. if there is good signal quality, you will see two 200msc blinks (off) every 4.5 seconds.
3 Start Up
Warning – You must connect an antenna to the SMA style antenna connector on the SkyRouter before turning it
on. Failure to do this could result in erratic start up behavior and could possibly damage the unit.
3.1 Power
Before starting connect the supplied 12VDC power adapter to the power connector described in Section 3. The adapter
supplied with your SkyRouter is suitable for use with 120VAC 60-hertz wall power. If you need a different power solution
contact Ctek.