Software Owner's manual

TurboVUi Solo Software Installation and Configuration Guide
3
INTRODUCTION
The TurboVUi Solo client presents a virtual radio on a PC’s desktop. With a PC or Laptop, and a network connection,
group or private calls are as easy as making a selection from the subscriber list, then clicking the Push-to-Talk button.
The TurboVUi Solo client can be used for simultaneous radio sharing instead of tone remotes; this simpler solution allows
users of the shared radio to have push-to-talk and listen capabilities, as well as access to all other radio functions.
TurboVUi Solo can also be used for situations when someone is outside of radio coverage, yet still needs to communicate
on the radio system, such as:
 Supervisory remote monitoring of radio channels
 Underground or building facilities that prevent radio communications
 A home office that is beyond the coverage area of a radio system
INSTALLATION OF TURBOVUI SOLO CLIENT MAY NOT BE REQUIRED
A TurboVUi System will require installation of at least one TurboVUi Solo Client, one TurboVUi Dispatch Client, or one
TurboVUi Pocket™ app for mobile devices. All client types may be installed in the same TurboVUi System. Installation
of the Solo Client is not necessary if only the TurboVUi Dispatch Client or TurboVUi Pocket™ App is needed and
installed.
WHAT YOU WILL NEED
PCs that will be used to run the TurboVUi Client Software must have the following:
 Windows XP, 7, or 8 Operating System
 IP Network Interface, 10Mbps or faster
 Speaker (internal to PC or powered external) or Headphones
 Microphone, see Connect a Microphone on Page 4 for recommended microphones
COMPATIBILITY
The TurboVUi Solo client and IP Gateway are compatible if the first two numbers of the software version match. For
example, TurboVUi Solo client software Version 6.0.x is compatible with IP Gateway with Version 6.0.x firmware.