Specifications

DRIVING THE TRACTOR
(InternationalCub Cadet 71, 102 and 122 Tractors)
CLUTCH AND BRAKE PEDAL
The combination clutch and brake pedal is
used to disengage the engine from the trans-
mission when shifting gears and to actuate the
brake to stop the tractor. The pedal must be
pressed all the way down to activate the safety
starting switch when starting the engine.
To disengage the clutch, press the pedal
approximately half way down. To stop the trac-
tor press the pedal all the way down.
LOCKING THE BRAKE
Always lock the brake when the tractor is
parked on a grade. To lock the brake, press
down on the brake pedal; then place the brake
pedal lock in the engaged position. To disen-
gage the lock, press down on the brake pedal
liftthe lock up and place it in the disengaged
position behind the brake pedal as shown in
Illust. 17A.
Note:Do not rest your foot on the pedal
while driving the tractor, as this will result
in excessive clutch lining wear.
Always be sure the rear wheels are free
to turn. Under any adverse conditions, do not
attempt to free the tractor by speeding up the
engine and suddenly engaging the clutch. Try
backing out instead of going forward.
STOPPING THE TRACTOR
Disengage the clutch by pressing the pedal
all the way down. Move the gearshift lever to
the neutral position.
CREEPER SHIFT LEVER
The creeper drive provides a slower speed
in each respective gear, by a four-to-one re-
duction in speed from direct drive. When the
creeper shift lever is all the way forward, it
is in direct drive, or all the way rearward, it
is in creeper drive. See Illust. 3. Note: Do not
use a mid-point position on the creeper drive
as neutral. Neutral position must be selected
only with the standard transmission gearshift
lever.
GEARSHIFT LEVER
This lever is used to select various gear
ratios provided in the transmission. There
are three forward speeds and one reverse
speed. See Illust. 3. Refer to "SPECIFICATIONS"
on page 32.
OPERATING THE CREEPER DRIVE
To operate the tractor in creeper drive,
move the creeper shift lever (illust. 3) all the
way rearward. Then select the speed desired
and proceed as instructed under "Starting the
Tractor".
STARTING THE TRACTOR
1. Advance the throttle lever slightly. See
Illust. 3.
Z. Disengage the clutch by pressing the
clutch pedal all the way down, and move the
gearshift lever to the desired speed.
3. Start the tractor in motion by slowly
releasing the clutch pedal and moving the
throttle lever to the position where the engine
operates best for the load to be handled.
Note: Do not shift gears while the engine
clutch is engaged or while the tractor is in
motion.
The following table shows the speeds avail-
able in each of the three forward gears and the
reverse gear.
Miles Per Hour
Gear
First
Second
Third
Reverse
Direct
Drive
Z. 3
3.9
6.8
Z. 5
Creeper
Drive
.6
1.0
1.7
.6