Specifications

PNEUMATIC TIRES
OPERATING PRESSUREFOR TIRES
Inflate the front and rear tires for normal
or heavy load operations as shown in the fol-
lowing table.
Front Tires
4o 00-8
16 x 6_ 50-8
Rear Tires
6_IZ
23x 8_50_1Z
Load
8
6
6
Heavy Load
square inch
i0
6
8
6
MOUNTING TIRES ON THE RIM
After mounting a new or old tire on the
rim, inflate it to ZO pounds pressure to seat
the tire bead on the rim flange and to prevent
the tire from creeping and shearing off the
valve. Then deflate the tire to the correct
ope rating pre s sure.
REAR WHEEL WEIGHTS
Rear wheel weights increase traction and
reduce wheel slippage. The weights weigh
approximately Z6 pounds each. They are
attached to each rear wheel with two bolts,
lock washers, and hex. nuts.
If additional weight is desired, a second set
of weights can be attached to each first weight
by using two longer bolts.
TIRE CHAINS
Tire chains will provide additional traction
for wet ground conditions, when plowing snow,
or pulling heavy loads. Rear wheel weights
are recommended when using chains.
CLUTCH AND BRAKE
(International Cub Cadet 71, 102 and 122 Tractors)
Clutch disengaged:
tractor must be
free to coast.
Clutching zone,
Neutral zone:
Both brake and clutch
are disengaged when
pedal is in this zone.
Braking zone:
Brake must be engaged
when pedal is in this zone.
1- 5/16-inch
3/4-inch minimum
Brake must be fully engaged
pedal arm reaches this position.
Ff_ ..............C utch engaged
%
Top surface of
pedal foot pad
/
Pedal stop
Foot support _J
(Model 71)
return stop
movement
(3/16-1nch)
Foot support
(Models 102 and 122)
A-84133
Illust. 21
Clutch and brake adjustments.
Zl