Specifications

LUBRICATION GUIDE
(InternationalCub Cadet 71, 102 and 122 Tractors)
- - After Every 10 Hours of Operation
1 - Oil filler cap and bayonet-type
oil level gauge.
2- Steering knuckles (2).
3- Front axle pivot pin.
Check the oil (with the engine stopped) and add sufficient
new oil to bring it to the "FULL" mark on the gauge. Do
not overfill. Do not operate the engine if the oil level is
below the "LOW" mark on the gauge.
I Use IH-Z51 HEP grease or equivalent #2 multi-purpose
lithium grease and apply sufficient grease to flush out old
grease and dirt.
After Every 30 Hours of Operation
- Engine crankcase.
While the oil is warm, remove the drain plug (4)and drain
allof the oil from the crankcase. Replace the drain plug.
Remove the crankcase oilfillercap (I).Refillthe crank-
case with new oilup to the "FULL" mark on the oillevel
gauge. Refer to the "Lubrication Table" for the proper
quantityand viscosityto use.
After Every 100 Hours of Operation
S-Power take-off shaft bearing
Transmission
6- Oil level and filler plug.
7- Oil drain plug.
Use IH-Z51 HEP grease or equivalent #Z multi-purpose
lithium and apply two or three strokes of the lubri-
grease
cator to the lubricationfittings.
O --Periodic
Check the oillevelperiodically.Keep the lubricantup to
the level plug (6)on the rear of the transmission case.
Change the oilin the transmission case at least once a
year. Remove the drain plug (7)and remove the oillevel
and fillerplug (6)and allow allof the oilto drain out. Re-
place the drain plug. Refillwith approved lubricant up to
the level plug opening and replace the plug.
Creeper drive housing
8 - L.eveI plug.
9. Breather and filler plug.
10. Drain plug.
11 - Steeringgear housing.
Miscellaneous
Check the oil level periodically. Keep the lubricant up to
the level plug (8) on the left side of the creeper drive
housing. Drain and refill the housing each time the oil is
changed in the transmission case. To change the oil, re-
I move the drain plug(10) at the bottom of the housing and
_ allow all the oil to drain. Then replace the drain plug.
I Remove the breather and oil filler plug (9) at the right
of the shift handle on of the frame assembly,
creeper top
L and remove the oil level plug (8) . Fill to the level plug
opening with approved lubricant and replace the plugs.
Once a year, apply two strokes of the lubricator, using
IH-Z51 HEP grease or equivalent #Z multi-purpose lithium
grease.
Note':To locate the lubrication fitting, turn the front
wheels to the maximum right turn position.:Then reach up
under the right side of the tractor frame to locate the
fitting.
l Lubricate the clutch pedal shaft and linkage with eight or
ten drops of engine oil.
Z9