Instructions / Assembly

Assembly & Installation

Figure 4-2

2. Secure the mounting bracket assembly to the tractor using

two 911-0310 clevis pins and 914-04023 cotter pins from

hardware pack 689-00320. See Figure 4-3.

Figure 4-3

NOTE: When installing this mounting bracket assembly onto

the tractor, two mounting holes may be present, as shown in

the inset of Figure 4-3. Insert the clevis pins in whichever of

the mounting holes that line up on your specific tractor.

3. Tighten all of the hardware installed at this time.

4. Install the upright support bracket onto the mounting

assembly on the tractor by hooking it over the mounting

assembly as shown in (1) Figure 4-4.

NOTE: References to left, right, front and rear of the tractor are

from the operator’s position, unless otherwise stated.

• Before assembly, place the tractor on a firm, level surface,

disengage the PTO, stop the tractor engine and set the

parking brake.

Assemble Mounting Brackets

To assemble the bagger mounting assembly, locate the

mounting assembly parts, as shown in Figure 4-1, and follow

these steps:

1. Attach the two hitch side brackets to the rear attachment

bracket using four 710-0276 carriage bolts and 712-04063

flange lock nuts from hardware pack 689-00320. See Figure

4-1.

Figure 4-1

Note: When assembling this mounting assembly, it is best to

not fully tighten the bracket at this time. This will facilitate the

mounting process in later steps, which will then require fully

tightening this mounting assembly.

Mount Assembly on Tractor

Install mounting assembly on tractor as follows:

1. Slide the mounting bracket assembly along the frame rails

of the tractor until the hooks in the mounting brackets

align under the shoulder bolts on your tractor, as seen in

Figure 4-2.