Use and Care Manual

8 Section 3— ASSembly & Set-Up
3. Align the holes in the chute base with the holes in the
lower chute and secure with the previously removed hex
washer screws. See Figure 3-6.
Figure 3-6
Installing Chute Rotation Control Assembly (Model 221 LHP only)
1. Remove the four hex washer screws from the back of the
handle (two on each side). See Figure 3-7.
Figure 3-7
Installing the Chute
1. On the 221 HP model place the chute handle on the lower
chute as shown in Figure 3-4. Skip to step 2 for 221 LHP
models. Be certain that the handle is aligned in the channel
on the chute and the tabs snap into place.
Channel
Tab
Figure 3-4
2. Remove the hex washer screws in the chute base. See
Figure 3-5.
Hex Washer
Screw
Figure 3-5