Use and Care Manual

20
OPERATION
M. 4-WAY CHUTE ROTATION CONTROL (IF EQUIPPED)
The 4-Way chute rotation control is located on the left side of the
dash panel.
• To change the direction in which snow is thrown, squeeze
the button on the control and rotate to the right or to the left
(Figure 59).
• To change the distance which snow is thrown, move the
control forward or backward.
Figure 59
N. ELECTRIC CHUTE PITCH & ROTATION CONTROL
(JOYSTICK) (IF EQUIPPED)
The electric chute control is located on the right side of the dash
panel (Figure 60).
• To change the direction in which snow is thrown, move the
joystick to the right or to the left.
• To change the distance which snow is thrown, move the
joystick forward or backward.
Figure 60
O. MANUAL CHUTE ROTATION CONTROL & ELECTRIC CHUTE
CONTROL (JOYSTICK) (IF EQUIPPED)
Follow this procedure to manually change the chute direction
on models equipped with an electric chute control (joystick) and
manual chute rotation control rod only (Figure 62).
1. Remove cotter pin (a) from either of the holes furthest from
the chute assembly on chute control head (Figure 61).
a
a
Figure 61
2. Push in chute control rod until the hole in it lines up with the
third hole in chute control head (Figure 61).
3. Reinsert cotter pin (a) through this hole and chute control
rod (Figure 61).
4. Grasp indented portion of chute control rod and manually
J. OVERHEAD CHUTE ROTATION CONTROL (IF EQUIPPED)
The overhead chute rotation control is located at the rear of the
snow blower under the handle panel. To change the direction in
which snow is thrown, rotate the control (Figure 56).
Figure 56
K. CHUTE-PITCH CONTROL (IF EQUIPPED)
The two-way chute-pitch control is located on the left side of the
dash panel and is used to raise and lower the upper chute, which
will change the distance the snow is thrown.
To raise or lower the upper chute, move the lever forward or
backward (Figure 57).
Two-Way Chute-Pitch Control
• To Reduce the Distance Snow is Thrown: Move the lever
forward to tilt the upper chute down (Figure 57).
• To Increase the Distance Snow is Thrown: Move the lever
rearward to tilt the upper chute up (Figure 57).
Two-Way Indexed Chute-Pitch Control
• To Reduce the Distance Snow is Thrown: Disengage lever
from the current chute setting. Move the lever forward to tilt
the upper chute down to the desired setting (a) (Figure 57).
• To Increase the Distance Snow is Thrown: Disengage lever
from the current chute setting. Move the lever rearward to
tilt the upper chute up to the desired setting (b) (Figure 57).
TWO-WAY INDEXED CHUTE-PITCH CONTROL
CHUTE TILT
DOWN
CHUTE TILT
UP
a
b
TWO-WAY CHUTE-PITCH CONTROL
Figure 57
L. 2-WAY CHUTE ROTATION CONTROL (IF EQUIPPED)
The 2-Way chute rotation control is located on the left side of the
dash panel.
• To change direction in which snow is thrown, squeeze button
on control and rotate to the right or to the left (Figure 58).
Figure 58