Use and Care Manual

8 Section 3— ASSembly & Set-Up
2. Insert chute control rod into chute control head. Push rod as far
into chute control head as possible, keeping the holes in
the rod pointing upward. See Figure 3-4.
Figure 3-4
3. Place chute onto chute base and ensure chute control rod
is positioned under the handle panel. Install hex bolt
previously removed but do not secure with wing nut at this
time. See Figure 3-5.
Figure 3-5
4. Squee ze the trigg er on the joysti ck and rotate the chute by hand
to face forward. The holes in the chute control input will be
facing up. See Figure 3-6.
Top View
Chute Control
Input
Figure 3-6
NOTE: The chute will not rotate without squeezing the
trigger on the joystick.
5. Rotate the joystick to the one o’clock position so that the silver
indicator arrow on the pinion gear below the control panel
faces upward. See Figure 3-7.
Figure 3-7
NOTE: The joystick will be angled slightly to the right at the
one o’clock position. See “Top View” in Figure 3-6.