User guide

3 - 1
Cub Cadet 3000
1. Slide the seat back and remove the front two pan
torx head screws using a T30 torx.
2. Slide the seat forward and remove the rear two
pan torx head screws using a T30 torx.
3. Pivot the seat assembly to the side and
disconnect the seat safety switch. See figure 1.
NOTE: Be careful not to scratch the fender with
the seat support brackets. It is advisable to use a
towel or cloth under the seat when pivoting the
seat.
4. Remove the seat from the tractor. See figure 1.
5. Remove all the hex bolts securing the three foot
pedals to the right side of the unit using a 9/16
socket. See figure 2.
Fender Assembly Removal and Reinstallation
FIGURE 1.
Torx Screws
Seat Safety
Switch
FIGURE 2.
Hex Bolts
Hex
Bolts
Reverse
Pedal
Forward
Pedal
Brake
Pedal
FIGURE 3.
Hex Bolt
Differential Lock
Out Pedal
Nylon Flange
Bearing
E-Clip
6. Remove the hex bolt securing the differential lock
out pedal on the left side of the unit using a 9/16
socket. Remove the “E” clip and the nylon flange
bearing from the pivot shaft.
FIGURE 4.
Wing
Nut
Side Panel Latch
Dash
Screen
Side Panel Latch
Rubber Foot Pads
7. Remove both rubber floor pads from the running
boards. See figure 4.
8. Lift the hood and remove the battery cover.
9. Remove both side panels from the tractor by
raising the latches horizontally and turning the
latches 1/4 turn. See figure 4.
10. Loosen all four plastic wing nuts holding the dash
panel screen in place. See figure 4.
11. Pull the dash screen towards the rear of the unit
and out of the dash panel. See figure 4.