User guide

10 - 2

Cub Cadet 3000

10. Remove the hydraulic tubes from the hydraulic

steering pump.

NOTE: If the hydraulic tubes do not want to come

out, use a small mallet and tap them out of the

ports. Be careful not to damage the tubes.

11. Inspect the “O” rings on the connectors for

damage. If damaged, replace.

NOTE: Place a small amount of grease on the

“O” rings and cover the connector surface

completely for reinstallation.

FIGURE 5.

“O” Rings

12. Support the hydraulic steering pump from below.

See figure 6.

13. Remove the four hex cap screws securing the

hydraulic steering pump to the frame using a

10mm wrench. See figure 6.

FIGURE 6.

Hex Cap

Screws

Steering

Pump

FIGURE 7.

Return

Auxiliary

Steering

Main Pressure

Refer to the 1998 Cub Cadet Technical Update

Seminar manual for inspection and repair of the Char-

Lynn 2 series Steering Control in Section 17.

REASSEMBLE THE HYDRAULIC STEERING PUMP

IN THE REVERSE ORDER.

14. Remove the hydraulic steering pump from the

tractor.