User guide

13 - 2
Cub Cadet 3000
FIGURE 5.
Neutral Return
Spring
Transmission
Support
Bracket
Front
Transmission
Support
Screws
Hex Flange
Lock Nut
17. Brace the transmission.
18. Remove all four of the front transmission support
bracket to frame hex cap screws and hex flange
lock nuts using a 9/16 wrench and a 9/16 socket.
See figure 5.
NOTE: The differential lock cable retainer bracket
is removed along with the transmission support
bracket.
19. Remove the “Z” fitting from the differential lock
actuator arm. See figure 6.
FIGURE 6.
Differential Lock
Actuator Arm
FIGURE 7.
Front of Tractor
Lock Nut
Flat Washer
Elongated
Slot
Lower
Point
20. Remove both transmission to frame “U” bolts
using a 3/4" socket. See figure 7.
NOTE: The “U” bolts have a lower point on one
side. The point goes towards the rear of the unit
during reassembly. See figure 7.
“Z” Fitting
Cable
Retainer
Bracket
21. Lower the transmission from the unit.
NOTE: Be certain that the rear control rod is
removed from the hydro neutral return plate as
the transmission is removed. Also, make certain
the brake levers clear the frame.
FIGURE 8.
Differential
Lock Cable
Fan
Charge
Pump
Brake
Assembly
Brake
Assembly
Oil Fill
Tube
Washers
Washers
Elastic
Lock Nuts
“U”
Bolt
“U”
Bolt
Support Plate Support Plate
REASSEMBLE THE TRANSMISSION TO THE UNIT
IN THE REVERSE ORDER ABOVE.