User guide

14 - 4
Cub Cadet 3000
FIGURE 14.
FIGURE 15.
FIGURE 13.
FIGURE 16.
Bearing
Block
Bevel
Gear
Needle Thrust
Bearing
Thrust
Washer
Bearing
Block
Flat
Washer
Shims
Output
Shaft
Input Pinon
Gear
Differential
Lock
Housing
Pin Engaged Differential
Lock Collar Ass’y.
Shims
Output
Shaft
Differential
Ass’y.
w/Differential
Lock
Compression
Spring
Axle Spacer
Differential Ass’y.
w/o Differential Lock
9/16 Hex Cap
Screws
Spur Gear 60T
Differential
Lock
Housing
9/16 Hex
Cap Screw
Differential
Gears
Thrust Miter Block
Spur
Gear
14T
32. Write down the shim orientations for both sides of
the output shaft. See figure 13.
33. Remove the output shaft assembly from the case
and inspect for any wear.
34. Remove the input pinion gear assembly from the
case. See figure 15.
35. Remove the four hex cap screws from the
differential housing using a 9/16 socket. See
figure 16.
36. Separate the differential assembly.
37. Remove the large spur gear and the differential
gears together and lay them on the bench.
38. Grasp the large spur gear and pull it away from
the differential gear assembly.
FIGURE 12.
Spur
Gear
Differential Lock
Actuator Shaft
Bevel
Gear
Output Shaft
Inner
Bearing
Block
Outer
Bearing
Block
INSPECT ALL COMPONENTS AND PARTS
BEFORE REASSEMBLY.