Specification

14 Section 6 — Maintenance
WARNING: If the engine has been running, the

muffler.
2. Visually inspect the spark plug. Discard the spark plug
if there is apparent wear, or if the insulator is cracked or
chipped. Clean the spark plug with a wire brush if it is to be
reused.
3. Measure the plug gap with a feeler gauge. Correct as

gap should be set to 0.024-0.031 in.
Electrode
0.024-0.031 in.
Figure 6-10
4. Check that the spark plug washer is in good condition
and thread the spark plug in by hand to prevent cross-
threading.
5. After the spark plug is seated, tighten with a spark plug
wrench to compress the washer.
NOTE: When installing a new spark plug, tighten 1/2 turn
after the spark plug seats to compress the washer. When
reinstalling a used spark plug, tighten 1/8-1/4 turn after the
spark plug seats to compress the washer.
IMPORTANT: The spark plug must be securely tightened.
An improperly tightened spark plug can become very hot
and may damage the engine.
Fuel Filter Service
The fuel filter cannot be cleaned and should be replaced every

1. Remove all fuel from tank by running engine until it stops
from lack of fuel.
2. Use pliers to squeeze tabs on the clamps, then slide the

Fuel Filter
Fuel Line
Tab
Clamp
Figure 6-11
3. Twist and pull the fuel lines off of the fuel filter.
4. Replace with a new fuel filter.
5. Secure the fuel lines with the clamps.