Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty Operator’s Manual Self Propelled Mower — Model CC 98 & CC 98M WARNING READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY. CUB CADET LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019 Printed In USA Form No.
1 To The Owner Thank You Thank you for purchasing a Lawn Mower manufactured by Cub Cadet. It was carefully engineered to provide excellent performance when properly operated and maintained. If applicable, the power testing information used to establish the power rating of the engine equipped on this machine can be found at www.opei.org or the engine manufacturer’s web site. Please read this entire manual prior to operating the equipment.
Important Safe Operation Practices 2 WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol.
12. A missing or damaged discharge cover can cause blade contact or thrown object injuries. 13. Many injuries occur as a result of the mower being pulled over the foot during a fall caused by slipping or tripping. Do not hold on to the mower if you are falling; release the handle immediately. 14. a. Step back from mower to fully extend your arms. b. Be sure you are well balanced with sure footing. c. Pull the mower back slowly, no more than half way toward you. d. Repeat these steps as needed.
Service 3. Check the blade and engine mounting bolts at frequent intervals for proper tightness. Also, visually inspect blade for damage (e.g., bent, cracked, worn) Replace blade with the original equipment manufacture’s (O.E.M.) blade only, listed in this manual. “Use of parts which do not meet the original equipment specifications may lead to improper performance and compromise safety!” 4. Mower blades are sharp and can cut. Wrap the blade or wear gloves, and use extra caution when servicing them.
Notice Regarding Emissions Engines which are certified to comply with California and federal EPA emission regulations for SORE (Small Off Road Equipment) are certified to operate on regular unleaded gasoline, and may include the following emission control systems: Engine Modification (EM), Oxidizing Catalyst (OC), Secondary Air Injection (SAI) and Three Way Catalyst (TWC) if so equipped.
Safety Symbols This page depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Symbol Description READ THE OPERATOR’S MANUAL(S) Read, understand, and follow all instructions in the manual(s) before attempting to assemble and operate DANGER — ROTATING BLADES To reduce the risk of injury, keep hands and feet away.
Section 2 — Important Safe Operation Practices Figure 1 line Figure 2 (TOO STEEP) 15° Slope WARNING! Slopes are a major factor related to tip-over and roll-over accidents which can result in severe injury or death. Do not operate machine on slopes in excess of 15 degrees. All slopes require extra caution. Always mow across the face of slopes, never up and down slopes. To check the slope, proceed as follows: 1. Remove this page and fold along the dashed line. 2.
3 Assembly & Set-Up Contents of Carton • One Lawn Mower • One Grass Catcher • One Side Discharge Chute • One Lawn Mower Operator’s Manual • • One Bottle of Oil Assembly 2. NOTE: This unit is shipped without gasoline or oil in the engine. Fill up gasoline and oil as instructed in the accompanying engine manual BEFORE operating your mower. • One Engine Operator’s Manual Locate the hairpin clip on the weld pin on each side of lower handle. a. Handle 1.
3. The rope guide, which is connected to the support rod, is located on the right side of the lower handle. See Fig. 3-3. 2. A Replace with grass bag adapter, while making sure the front lip of adapter goes under the edge of the deck. Refer to Fig. 3-4. Secure with wing nuts previously removed. 2 B C Figure 3-3 a. Hold blade control against upper handle. b. Pull starter rope out of the engine. Release blade control. c. Slip starter rope into rope guide. 4.
4. Lift chute door on the grass bag adapter and slide grass bag onto the adapter. See Fig. 3-6. Adjustments Cutting Height The cutting height adjustment lever is located above the rear left wheel. See Fig. 3-8A insert. A 2 3 1 4 B C B Figure 3-6 Side Discharge Chute 2 1 Figure 3-8 Follow steps below to install the side discharge chute: 1. Remove mulching baffle or grass bag adapter from unit by disconnecting wing nuts. 1. Pull lever out and away from mower. 2.
Drive Control Set-Up The adjustment wheel is located in the drive control handle housing and is used to tighten or loosen the drive belt. You will have to adjust the drive control if any of the following happens: Gas and Oil Fill-Up 1. The mower does not propel itself with the drive control engaged. 2. The mower’s drive wheels hesitate with the drive control engaged.
4 Controls and Features Blade Control Drive Control Cutting Height Adjustment Lever Recoil Starter Side Discharge Chute Figure 4-1 Blade Control Side Discharge Chute The blade control is attached to the upper handle of the mower. Depress and squeeze it against the upper handle to operate the unit. Release it to stop engine and blade. Your mower is shipped as a mulcher.
5 Operation Starting Engine WARNING: Be sure no one other than the operator is standing near the lawn mower while starting engine or operating mower. Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an odorless and deadly gas. Keep hands, feet, hair and loose clothing away from any moving parts on engine and lawn mower. 1. Standing behind the mower, squeeze and hold the blade control against upper handle. 2.
6 Maintenance & Adjustments Maintenance 2. Lubricate the wheels and casters at least once a season with light oil (or motor oil). If wheels are removed for any reason, lubricate the axle bolt and inner surface of the wheel with light oil. See Fig. 6-1. General Recommendations • Always observe safety rules when performing any maintenance. 3. • The warranty on this lawn mower does not cover items that have been subjected to operator abuse or negligence.
Engine Care Replacing Rear Flap NOTE: Refer to the Engine Operation and Maintenance sections in the engine manual for detailed instructions. To replace rear flap, proceed as follows: • Maintain oil level. • Service air cleaner every 100 hours or once a season under normal conditions. Clean more frequently under extremely dusty conditions. • Clean spark plug and reset the gap once a season. • Clean engine regularly with a cloth or brush.
7 Service Blade Care WARNING: When removing the cutting blade for sharpening or replacement, protect your hands with a pair of heavy gloves or use a heavy rag to hold the blade. WARNING: An unbalanced blade will cause excessive vibration when rotating at high speeds. It may cause damage to mower and could break causing personal injury. 5. Lubricate the engine crankshaft and the inner surface of the blade adapter with light oil. Slide the blade adapter onto the engine crankshaft.
8 Troubleshooting Problem Engine Fails to start Cause Remedy 1. Blade control disengaged. 1. Engage blade control. 2. Spark plug boot disconnected. 2. Connect wire to spark boot. 3. Fuel tank empty or stale fuel. 3. Fill tank with clean, fresh gasoline. 4. Engine not primed (if equipped with primer). 4. Prime engine as instructed in the Operation section. 5. Faulty spark plug. 5. Clean, adjust gap, or replace. 6. Blocked fuel line. 6. Clean fuel line. 7. Engine flooded. 7.
Problem Mower will not mulch grass Cause Remedy 1. Wet grass. 1. Do not mow when grass is wet; wait until later to cut. 2. Excessively high grass. 2. Mow once at a high cutting height, then mow again at desired height or make a narrower cutting path. 3. Dull blade. 3. Sharpen or replace blade. Uneven cut 1. Dull blade. 1. Sharpen or replace blade. Mower will not self propel 1. Belt not installed properly. 1. Check belt for proper pulley installation and movement. 2.
9 Replacement Parts & Accessories Component Accessories Part Number and Description 951-10292 Spark Plug 951-10298 Air Cleaner Kit 951-10300 Fuel Cap Assembly 951-10358A Fuel Filter 734-2010B 734-1857 Wheel (Rear) Wheel (Front) 731-1832 Side Discharge Chute 964-04112 Grass Bag 942-0741A 942-0741A-X Mulching Blade Xtreme Mulching Blade 954-0460 V-Belt 490-850-0005 490-850-0008 Blade Removal Tool Oil Siphon Phone (800) 965-4CUB to order replacement parts or a complete Parts Manual (have
Notes 21
CUB CADET LLC MANUFACTURER’S LIMITED WARRANTY FOR WALK-BEHIND MOWERS IMPORTANT: To obtain warranty coverage owner must present an original proof of purchase and applicable maintenance records to the servicing dealer. Please see the operator’s manual for information on required maintenance and service intervals.