Operator`s manual

9Section 3 — ASSembly & Set-Up
Adjustments
Nozzle Height
Thenozzlecanbeadjustedtoanysixpositions,rangingfrom
5/8”to41/8”groundclearance.Thenozzleheighthastobe
adjustedaccordingtochippershredderconditions.
1. Depressnozzleheightadjustmentlevertowardswheel.
SeeFigure3-7.
3
2
1
Figure 3-7
2. Movetheheightadjustmentleverforwardorbackwardto
adjustthenozzleupwardsordownwards.Makesureboth
leversareinthesameposition.
3. Releaselevertowardsdeck.SeeFigure3-7.
NOTE: Ingeneral,raisethenozzleheighttovacuuma
thicklayerofleaves.Lowerthenozzleheightforsmoother
surfaces.
Set-Up
Gas and Oil Fill-Up
Refertotheseparateengineowner’smanualforadditional
engineinformation.
1. Addoilprovidedbeforestartingunitforthefirsttimeout
ofthebox.
2. Servicetheenginewithgasolineasinstructedinthe
separateengineowner’smanual.
WARNING: Useextremecarewhenhandling
gasoline.Gasolineisextremelyflammableandthe
vaporsareexplosive.Neverfuelthemachine
indoorsorwhiletheengineishotorrunning.
Extinguishcigarettes,cigars,pipesandother
sourcesofignition.
WARNING: Neverfillfueltankindoorswithengine
runningoruntiltheenginehasbeenallowedtocool
foratleasttwominutesafterrunning.
Bag
1. Graspbaghandlewithonehandandslidelockingrodon
mountingbracketwithotherhandtowardengine.Use
theendofmountingbracketasleveragewhenslidingthe
lockingrod.SeeFigure3-6.
4
3
1
2
Figure 3-6
2. Slipbagovertherimofthedischargeopeningandrelease
lockingrodtosecurebaginplace.
3. Snapbagcliptothetopofthelowerhandle.
4. Placethelowerstrapsonthebagoverthetopoflower
handle,hookingthemonthestuds.SeeFigure3-6.
NOTE: Thebag/chuteswitchbuttonattachedtothe
mountingbracketmustbefullydepressedbythetipof
fronttabonbaghandlewhensecuringthebagorengine
willnotstart.