Use and Care Manual

20
PRODUCT CARE
Removing the Battery Access Panel
Unlock the battery access panel under the seat by rotating the
lock knob, then lifting the battery access panel (Figure 13).
a
Figure 13
Removing the Engine Access Panel
Lift up on the handle (a) near the front of the engine access panel
under the seat, then remove the engine access panel (Figure 14).
a
Figure 14
Removing the Air Filter Access Panel
Remove the two screws (a) securing the air filter access panel (b)
to the front of the seat box (Figure 15).
a
Figure 15
Jacking Up the Utility Vehicle
WARNING
To avoid personal injury, death, or vehicle damage do not
work under the vehicle unless it is secured by safe stands
or suitable blocking.
1. Jack up the front end of the utility vehicle on the front frame
tube (a) only (Figure 16).
a
Figure 16
2. Jack the rear of the utility vehicle only after placing a wooden
block under the right (a) and left frame tube (b) for securing
the engine and then supporting it. Do not apply jack pressure
on the steel plate directly under the engine (Figure 17).
a
b
Figure 17
Adjusting the Doors
If the gaps around the doors are uneven, the door can be
adjusted. To adjust the doors, loosen the two bolts (a) on each
hinge, adjust the door until an equal gap is achieved all the way
around. Retighten all four bolts (a) (Figure 18 on page 21).