Use and Care Manual

33
PRODUCT CARE
Problem Cause Remedy
Engine overheats
1. Cooling fan not turning
2. Coolant level is low
3. Air cleaner element missing
or plugged
4. Engine oil low
5. Radiator fins are clogged.
6. Coolant System
needs purged.
1. Listen or look for the radiator fan to turn on. The unit must be
running, or the key switch in the run position. If the dash indicates
the engine has over heated, immediately turn the unit off and
then turn the key switch to the run position. If the fan does not
turn on, check the fuses. If the fuses have not failed allow the unit
to cool off before attempting to operate again. The unit must be
stopped and allowed to cool to help avoid additional damage.
Contact your local authorized dealer for service immediately after
any overheating condition.
2. NEVER ADD COOLANT OR REMOVE THE RADIATOR CAP ON A WARM
OR HOT ENGINE. DOING SO CAN CAUSE SERIOUS INJURY. Check the
fluid level in the overflow reservoir and add as needed.
3. Inspect and clean/replace the air filter as needed. Ensure the
housing is properly closed after inspection/replacement.
4. Ensure the engine oil level is correct. The engine oil level should be
checked on a flat surface after the engine has had time to cool.
5. Use a garden hose with a sprayer attached, spray the back side
and then the front side of the radiator to clean the fins. The water
should spray through the fins in a mist.
6. If the unit is still showing signs of overheating, there maybe air
entrapped with the cooling system. Contact your local authorized
dealer for servicing.
Engine loses power 1. Engine overheating.
2. Too much oil in engine.
3. Faulty spark plug.
4. Air cleaner element plugged.
5. Fuel issues.
1. See Engine Overheating Section.
2. Contact your local authorized dealer for servicing.
3. Inspect, clean/replace the spark plug. Ensure the spark plug gap
is properly set.
4. Inspect, clean/replace the air filter. Ensure the housing is properly
closed after inspection/replacement.
5. Contact your local authorized dealer for servicing.
Starter does not work 1. Battery
2. Loose or
corroded connections
3. Starter
1. Check the battery voltage using a voltage meter set on the DC
setting. This check should be completed with the unit off and
while attempting to start the unit. While attempting to start the
unit, the voltage should not drop below 9.8 VDC. If the voltage
does drop below this, contact your local authorized dealer
for service.
2. Disconnect the negative battery terminal before attempting to
service. Inspect and clean as needed all electrical connections to
the starter. If you are unsure on how to preform this task, contact
your local authorized dealer for servicing.
3. If the starter is making a “clicking” sound, check the battery
voltage. If the battery voltage is ok, contact your local authorized
dealer for servicing.
Starter cranks slowly 1. Weak or Low Battery.
2. Worn Starter.
1. Check the battery voltage. If the voltage is low, clean the battery
terminals and connections prior to charging. If the battery will
not maintain a charge, contact your local authorized dealer
for servicing.
2. See “Starter does not work” section.