Use and Care Manual

6
SAFE OPERATION PRACTICES
6
SAFE OPERATION PRACTICES
Safety Labels
Safety labels that may appear on the product are reproduced on this page. Read, understand, and follow all instructions on the machine
before attempting to assemble and/or operate.
Battery
Remove rubber cap Connect exhaust tube
Exhaust opening
Instruction:
Preparing the battery for
lling with electrolyte (acid)
Take o the rubber sealing cap
and remove lling plugs.
Replace rubber cap with
exhaust tube provided.
Filling electrolyte (acid):
Fill battery with electrolyte (diluted sulphuric acid) with a specic
Gravity of: cool or temperate climate 1.270-1.280
Tropical climate 1.250-1.260
The electrolyte temperature when lling must not be lower than 15°c or
higher than 30°c.
Fill battery to upper level as indicated on the battery case.
Leave battery to stand for at least 30 minutes after lling.
Electrolyte level may fall during this period, rell to upper level
before charging.
WARNING
The battery contains or emits chemicals known in certain quantities to
cause cancer, birth defects or other reproductive harm.
Before setting up and operating your new utility vehicle please locate the model plate and record the information in the provided area
to the right. You can locate the model plate by looking on the frame above the left rear tire. See the image below. This information
will be necessary, should you seek technical support via our web site, Customer Support Department, or with a local authorized
service dealer.
SPARK ARRESTOR
WARNING
This vehicle is equipped with an internal combustion
engine and should not be used on or near any
unimproved forest-covered, brush-covered, or grass-
covered land unless the engine’s exhaust system is
equipped with a spark arrestor meeting applicable local
or state laws (if any).
SAFETY LABELS
Safety labels that may appear on the product are reproduced on this page. Read, understand, and follow all instructions on the machine
before attempting to assemble and/or operate.
The spark arrestor should be maintained in effective working
order by the operator. In the State of California the above is
required by law (Section 4442 of the California Public Resources
Code). Other states may have similar laws. Federal laws apply on
federal lands.
A replacement spark arrestor for the muffler is available through
your nearest engine authorized service dealer or contact the
service department, P.O. Box 361131, Cleveland, Ohio 44136-0019.